Honeycomb Workbench for Falcon Laser Engraver 500mm * 500mm

I have no idea how good the product is because I have not yet used it and that is because it came with no instructions on how to install, your customer service has little or no published information on how to install, there are conflicting opinions online as to weather to install it in the Falcon2 itself or in the tray underneath the Falcon2, etc. Why can you not have clear and concise instructions or video indicating how to install or what is the best installation under differing conditions and what king of recalibrations are required each time you remove it and reinstall it?

works great with machine

It is good that it does not just lie flat on the table, it is raised up allowing good airflow underneath. It is good that small magnets stick to it very well and hold thin sheets of wood in place very nicely.

We have a Creality falcon CR 10 and decided to stick with the Creality brand for the honeycomb. Really solid construction, and it is almost exactly as large as our laser engraver.

This seems to work fine and is apparently well built. There were zero instructions in the box but it's pretty simple to figure out. The rubber corner pieces won't work with the crumb tray so I had to remove them. However, removing them means there's no airflow through the honeycomb.

Fits unit perfect, and works well. If there was any suggestions, it would be that it had hold downs for projects. But that's a wish list.